STORAGE
The product must be stored in accordance with national regulations. Keep the containers in a dry, shaded, cool, well-ventilated space and away from sources of heat and ignition. Containers must be kept tightly closed. Handle with care. Shelf Life 24 months unopened. Store indoors at 4.5°C (40°F) to 38°C (100°F).
INTENDED USE
High-resistance internal tank coating developed for chemical storage vessels. This is ideally suited for the protection of tanks containing grey water, drilling mud, brine, and crude oil and offers reliable protection against a wide array of chemical products. Engineered for internal lining applications across offshore, onshore, and underground infrastructure, ensuring long-term integrity in surface-level or buried installations.
Average Drying Times:
| 4.5°C (40°F) | 10°C (50°F) | 25°C (77°F) | 38°C (100°F) | |
|---|---|---|---|---|
| Touch | 14 hours | 8 hours | 3 hours | 1 hour |
| Handle | 20 hours | 10 hours | 4 hours | 2 hours |
| Recoat | 24 hours | 12 hours | 4 hours | 2 hours |
| Cure | 13 days | 6 days | 4 days | 2 days |
| Pot life | 4 hours | 3 hours | 2 hours | 45 minutes |
Drying time is temperature, humidity, and film thickness dependent.
SURFACE PREPARATION
Surface must be clean, dry, and in sound condition. Remove all oil, dust, grease, dirt, loose rust, and other foreign material to ensure adequate adhesion.
Minimum recommended surface preparation: Iron & Steel: SSPC-SP6/NACE 3, 2 mil (50 micron) profile Stainless steel & Aluminum: Abrasive blast cleaning to achieve a surface profile using non-metallic abrasive media which is suitable to achieve a sharp and angular surface profile. Galvanizing: Sweep blast-cleaning using nonmetallic abrasive leaving a clean, rough and even pattern. Concrete: Dry abrasive blast cleaning to SSPCSP 13/NACE No. 6. Existing, aged coatings: SSPC-SP1 Solvent cleaning, then scarify / abrade the surface to ensure proper adhesion.
COLOR & GLOSS VARIATION
Slight deviations in color may occur between production batches of primer and antifouling products. When subjected to atmospheric weathering and solar radiation, these products as well as epoxy-based topcoats, may exhibit chalking. Furthermore, the retention of gloss and color in topcoats depends on several factors. These include the paint type, specific pigment selection, application standards, and environmental conditions such as temperature and UV intensity.
ADDITIONAL NOTES
The product is for professional use only. Personnel shall be trained, experienced, and use the equipment to mix/stir well and apply the product properly. Applicators shall use appropriate personal protection equipment when using this product. Always comply with New Belmont Coatings LLC technical data.
WARRANTY
New Belmont Coatings LLC warrants our products to be free of manufacturing defects in accordance with applicable NBC quality control procedures. Liability for products proven defective, if any, is limited to replacement of the defective product or the refund of the purchase price paid for the defective product as determined by NBC.
DISCLAIMER
The information and recommendations set forth in this Product Data Sheet are based upon tests conducted by or on behalf of New Belmont Coatings LLC. Such information and recommendations set forth herein are subject to change and pertain to the product offered at the time of publication. Published technical data and instructions are subject to change without notice. Contact New Belmont Coatings LLC for additional technical data and instructions.
